Malco Drip Edge Folding Tool
Malco 18" Wide Drip Edge Folding Tool DEFT1

Malco Drip Edge Folding Tool


Choose Options

DEFT1 18 Wide Drip Edge Bending Tool by Malco
DEFT 24 Wide Drip Edge Bending Tool by Malco




Bending Tools

Made In:


Malco's big 24-inch (61 cm) Drip Edge Folding Tool makes quick bends along the drip edge of flat-pan standing seam metal roofing panels. Versatile, compact 18-inch (46 cm) drip edge folding tool makes quick bends along the drip edge of flat-pan standing seam metal roofing panels. Two rib-reinforced steel plates are permanently welded together to create two folding seams for making 1-inch (25.4 mm) and 1-1/2-inch (38.1 mm) deep bends in maximum 22-gauge (0.76 mm) steel. A two-post-design, fiberglass reinforced nylon handle offers durable, lightweight strength and high leverage for working overhead or on a bench.


The DEFT Drip Edge bender from Malco. Buy from Rapid Materials

What gauge material will it bend?

It will bend up to 22 gauge material.

What materials does that translate to?

The tool will fold roofing panels, mild steel and it can also be used on galvanized steel for duct work.

Is there a special technique?

When bending the drip edge on roofing panels you should have the handle facing toward the finished side of the panel, then bend the edge around until the tool bottoms out on the back side. You can bend the panel either on the roof when it is in place or before it is installed.

Explain the type of bend that is achievable?

The finished bend ends up to be approximately 150°, which allows you to finish the seam with a Seamer, Malco s SG10 & SG11 Seamer & Tongs are recommended.

When is it better to use the DEFT instead of the other style folding tools?

The DEFT works better then other folding tool when doing drip edges on metal roofing. The handle on the tool provides added leverage to make bending the edge easy. Also the 1-1/2 depth accommodates for the deeper bend that is needed for the drip edge.

What do you use to finish off the bend after using the DEFT?

Malco s Seamer & Tongs, models SG10 (straight) or SG11 (offset) would work the best. The vinyl coated jaws prevent scratching of the paint on the roofing panel. The Seamer & Tongs also have a large opening to allow easy clamping on the bend and seam it without sliding off.

There are no reviews for this product!

Related Items

Recently Viewed Items